NSI SECURITY QUICK START

Set Up Your UNV Network Video Recorder

Follow four straightforward steps to connect your equipment, complete the startup wizard, enable remote viewing, and solve common display issues.

Illustrated example: UNV cameras, NVR, monitor, storage, network, and UniEase mobile viewing.

PHYSICAL SETUP

Connect the recorder and cameras

Place the NVR in a cool, dry location with adequate airflow.
Connect the supplied power adapter to the recorder and a properly grounded outlet.
Connect a monitor using HDMI or VGA, then plug in a standard USB mouse.
Connect IP cameras to the NVR’s built-in PoE ports. For a non-PoE recorder, connect the cameras through a compatible PoE network switch.

Ready when: The monitor displays the NVR startup screen and the connected camera ports show link activity.

INITIAL CONFIGURATION

Complete the startup wizard

Turn on the NVR and follow the on-screen startup wizard.
Create a strong, unique administrator password and securely save the password-recovery information.

CCTV 101: Set the time and synchronize your cameras

Accurate timestamps are essential when searching recordings, reviewing events, and exporting video evidence.

Time zone: Select the time zone for the installation location. For New Jersey and other Eastern Time locations, choose Eastern Time (US & Canada) or UTC−05:00.
Daylight Saving Time: Enable Automatic DST or DST so the recorder changes between UTC−5 and UTC−4 automatically.
Network time: Enable NTP synchronization and use a trusted time server such as pool.ntp.org. If the recorder requests a port, use NTP port 123.
Camera synchronization: Enable Synchronize Camera Time, IPC Time Sync, or the equivalent option so every connected camera follows the NVR’s clock. Menu names may vary by model and firmware.
Verify the result: Confirm that the NVR and every camera show the correct local time. Record a short test video and make sure playback opens at the expected timestamp.

Important: Use the NVR as the primary time source for all cameras at the same location. Avoid mixing manually configured camera clocks with automatically synchronized time.

Ready when: The NVR and all connected cameras display matching local timestamps, DST is enabled, a test recording can be found using the correct time, and you can open the main menu using the new administrator password.

REMOTE VIEWING

Connect the NVR to UniEase

Connect the NVR’s LAN port to your router or network switch using an Ethernet cable.
Open Network in the NVR settings and enable DHCP for automatic network configuration.
Open the EZCloud page and confirm that the recorder displays an online status.
Install UniEase on your phone, create an account, and sign in.
In UniEase, add a device and scan the QR code shown on the NVR’s EZCloud screen.

NetworkEZCloudUniEase

Download the UniEase setup guide (PDF)

DISPLAY TROUBLESHOOTING

Resolve a “No Resource” message

A “No Resource” message usually means the recorder does not have enough decoding capacity to display every selected camera stream at its current resolution. It does not necessarily mean the camera is offline.

Prioritize sub-streams: Open Menu → System → Preview → Advanced and enable the option that uses sub-streams during multi-camera live view.
Clear unused outputs: Open Menu → System → Preview → Preview and remove camera layouts from HDMI or VGA outputs that are not connected to a monitor. Select Apply.
Reduce the sub-stream load: Open Menu → Camera → Encoding, then lower the affected camera’s sub-stream resolution or bitrate. Apply the change and retest live view.
Check for approved firmware: Install only firmware that matches the exact NVR model and hardware revision.

Firmware safety: Never disconnect power or network access during an update. Contact NSI Security before upgrading if you are uncertain which file applies to your recorder.

NEED PERSONAL ASSISTANCE?

We can help you finish the setup

Menu names and available options can vary by recorder model and firmware version. Have the NVR model, serial number, and current firmware version ready when contacting support.

Contact NSI Security Call 856-317-0600